Marmitek AWM2 Uživatelský manuál stáhnout pdf (Strana 10)

Do the FD10 units need to be attached to the phase circuit?

Not necessarily. If you only want to couple and not filter, the

FD10 units can also be attached to the phases via a parallel

connection. This makes the installation a lot simpler.

After placing the FD10 units, my installation does not

work as well as before. What went wrong?

The FD10 units were not connected properly. The ingoing

and outgoing phases were switched round, which means

the FD10 suppresses the signals on the installation in your

house.

Can I use the FD10 also as a filter only?

Yes you can. Use the wiring diagram as in "Coupling and fil-

tering", but disconnect the K-connection.

What is the difference between 3 FD10s and the

CAT3000?

When using 3 FD10s, the signals are spread over different

phases (the phases are coupled). The CAT3000 couples the

phases and also amplifies the signal (repeater) and also cou-

ples the extra MicroModules signals.

What tricks and tips can I use to enhance the reach of

the X-10 signals?

See http://www.haibraincom/en/support/haibrain-university.php

for more information.

Do you still have questions? Please check out

http://www.haibrain.com. for more

information.

11FD10

1 2 ... 5 6 7 8 9 10 11 12 13

Žádné komentáře

Marmitek AWM2 Uživatelský manuál Strana 10