Marmitek AWM2 Uživatelský manuál

FD10FD10™PHASE COUPLER / FILTER20533/20120530 • FD10 ALL RIGHTS RESERVED HAIBRAIN©USER MANUAL

Do the FD10 units need to be attached to the phase circuit? Not necessarily. If you only want to couple and not filter, theFD10 units can also be atta

TECHNICAL SPECIFICATIONSSupply voltage: 230VAC, 50 HzMaximal current: 63 ACentral filter frequency: 120 kHzBandwidth filter: 5 kHz min. (3 dB poin

13FD10Environmental Information for Customers in the European UnionEuropean Directive 2002/96/EC requires that the equipment bearing this symbol on th

FD10™ PHASE COUPLER / FILTERSAFETY WARNINGS• The wiring of your electrical installation is live (230 V) andextremely dangerous. Never connect the modu

HOW DOES HAIBRAIN X-10 WORK?Haibrain X-10 components use the existing mains wiring to communicate (using Haibrain X-10 signals). You can build a compl

5LD11SIGNAL RANGERange of Haibrain X-10 signals over the Power Line and how to increase the range.The Haibrain X-10 System is based on power line com

When e.g. your conclusion is that e.g. your computermonitor is attenuating the signal, you can use a FM10 Plug-in Filter between the power line and th

machinery). If you think that your system is influenced by devices out of your house, it is advisable to install FD10 Phase Coupler/Filter on each pha

8© HAIBRAININSTALLATIONMAKE SURE THE MAINS ELECTRICITY IS SWITCHED OFFBEFORE INSTALLING THE MODULE!The module must be installed by a qualified electri

9FD10Simply click the FD10 onto the DIN rail.Connect the cables as follows: Phase input to (L)Null to (N)Phase output to (L)Use additional Phase Cou

FREQENTLY ASKED QUESTIONSWhat is the reason for modules to switch on/off spon-taneously?It is possible that a Haibrain X-10 System is installed at one