Marmitek PROTECTOR 28 Uživatelský manuál stáhnout pdf (Strana 14)

Up to 8 remote controls can be registered with the base station (KR10/1 and SH624/1).

1. Set mode switch to the INSTALL position: All indicators of occupied zones come on

2. Press an alarm key (e.g. DISARM) of the first remote control (e.g. KR10/1): One short confirmation beep. No extra zones

are occupied.

3. Press an alarm key (e.g. DISARM) of the second remote control (e.g. SH624/1): One short confirmation beep. No extra

zones are occupied.

4. Repeat these steps up to 8 remote controls.

5. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out

You can use your security system without the siren (only telephone dialler and lights). In case of a break in, the siren built

into the base station will not be activated. (N.B.: Extra external sirens will always be activated). The factory defaults have the

siren switched on.

1. Set the mode switch to the INSTALL position: All indicators of occupied zones come on

2. Key in your 4 digit PIN code (factory default [0000] refer to 5.8): One confirmation beep at every key press

3. Press key number 4: One short confirmation beep

4. Press ENTER: One short confirmation beep

5. Press 0 for silent alarm: One short confirmation beep

Press 1 for alarm with siren: One short confirmation beep

6. Reset the mode switch to the RUN 1 or RUN 2 position: Zone indicators go out

14 MARMITEK

5.2 REGISTRATION OF WIRELESS

REMOTE CONTROLS

5.3 SETTING THE SIREN ON/OFF

(LOUD/SILENT ALARM)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Žádné komentáře

Marmitek PROTECTOR 28 Uživatelský manuál Strana 14