Marmitek Gigavideo 40 Servisní příručka stáhnout pdf (Strana 13)

DIN Rail Switch (AD10)

230 VAC - 50 Hz - 16A LOAD RATING

Key Features

∗ Install at the breaker panel/fuse box for X-10 control of branch lighting circuits or

appliances rated up to 16 A- ideal for aircon, heaters etc.

∗ Works with X-10 controller and standard latched or momentary action wall switches -

including "designer" wall switches.

Benefits

The X-10 DIN rail switch is a remote

controlled relay. Discretly installed at the

junction box, it switches hard-wired

circuits with several switches (e.g.

hallway lighting).

The internal relay can be tripped either

by external latched or momentary action

wall switches or by an X-10 controller.

The AD10 responds to "standard" X-10

that is: "All units off" from any X-10

controller set to its house code regard-

less of unit code or alternatively indi-

vidual unit control by "On" and "Off".

When the relay is energized, the LED

above the slide switch is illuminated.

Slide switch:

Position 0: the connected load is

switched off permanently and cannot be

switched on by the wall switches or an X-

10 controller.

Position 1: the connected load is

switched on permanently and cannot be

switched off by the wall switches or an X-

10 controller.

Position auto: the connected load can be

switch by the wall switches or an X-10

controller.

Terminal 1 is designed for toggle

switches: the relay picks up when phase

is present and releases when there is

no voltage at the terminal.

Terminal 2 is designed for pulse con-

tacts : each time phase is applied the

relay switches.

Technical data

Supply voltage: 230 V +10% -15% 50 Hz

Supply current : ≤ 20 mA capacitive

Making capacity: 2000 W ( incandescent lamp)

3 A (motors)

16 A (resistive loads)

EMC emission: according to EN 50081-1

EMC immunity: according to EN 50082-1

Electrical safety: according to EN 60950 and EN 60065

Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz

Input impedance: ≥180 Ohms (L - N) at 120 kHz

Connections: screw type terminals for phase, neutral, switched

phase, control 1 and 2.

Ambient temperature: - 10° C to + 40° C (operation)

- 20° C to + 70° C (storage)

Typical applications

This unit can replace any pulse contact relay that is commonly used for multi

switched hall and entry lighting. In discrete locations, eg kitchen lighting, you

may prefer to install the AD10 in a small sub-junction box.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Komentáře k této Příručce

Žádné komentáře

Marmitek Gigavideo 40 Servisní příručka Strana 13

Komentáře k této Příručce

Související produkty a manuály pro Stmívače Marmitek Gigavideo 40